Samson 41-23 - Page 12

1-8 EB 2512 EN
Safety instructions and measures
NOTICE
!
Risk of excess pressure damaging plant sections due to construction-related seat
leakage through the regulator.
Î Alwaystasafetydevice(e.g.safetyexcesspressurevalveorsafetyreliefvalve)in
the plant.
Incorrect control due to the formation of ice on the regulator.
Mediumtemperaturesbelow0°Cmaycauseicetoformontheregulator,depending
on the air humidity. This may affect, in particular, the functioning of the plug or dia-
phragm stem guide.
Î Prevent the formation of ice by taking appropriate precautions (e.g. enclosure,
trace heater etc.). The plant operator is responsible for selecting and implementing
appropriate precautions. See the 'Installation' section.
SAMSON's After-sales Service can support you concerning lubricant, tightening torques
and tools approved by SAMSON.
Note