Samson 41-23 - Notes on Possible Personal Injury

EB 2512 EN 1-5
Safety instructions and measures
1.2 Notes on possible personal injury
WARNING
!
Crush hazard arising from moving parts.
Theregulatorcontainsmovingparts(setpointsprings),whichcaninjurehandsorn-
gers if inserted into the regulator.
Î Donotinserthandsorngersbetweenthesetpointspringswhiletheregulatoris
in operation.
Î Donotinserthandsorngersbetweenthepillarsandsetpointspringswhilethe
regulator is in operation.
Î Donotinserthandsorngersbetweenthespringplateandcrossbeamwhilethe
regulator is in operation.
Î Beforeperforminganyworkontheregulator,depressurizetheplant.Disconnector
shut off the control line.
Risk of personal injury through incorrect operation, use or installation as a result of
information on the regulator being illegible.
Over time, markings, labels and nameplates on the regulator may become covered
withdirtorbecomeillegibleinsomeotherway.Asaresult,hazardsmaygounno-
ticed and the necessary instructions not followed. There is a risk of personal injury.
Î Keep all relevant markings and inscriptions on the device in a constantly legible
state.
Î Immediately renew damaged, missing or incorrect nameplates or labels.
Risk of hearing loss or deafness due to loud noise.
The noise emissions depend on the valve version, plant facilities and process medium.
Î Wear hearing protection when working near the valve.
Risk of burn injuries due to hot or cold components and pipelines.
Depending on the process medium, regulator components and pipelines may get very
hot or cold and cause burn injuries.
Î Allow components and pipelines to cool down or heat up.
Î Wear protective clothing and safety gloves.