Samson 41-23 - Emergency Action Procedures

EB 2512 EN 8-3
Malfunctions
Contact SAMSON’s After-sales Service for
malfunctions not listed in the table.
Themalfunctionslistedinsection8.1are
caused by mechanical faults and incorrect
regulatorsizing.Inthesimplestcase,the
functioning can be restored following the
recommended action. Special tools may be
required to remedy the fault.
Exceptionaloperatingandinstallationcondi-
tions may lead to changed situations that
may affect the control response and lead to
malfunctions. For troubleshooting, the condi-
tions, such as installation, process medium,
temperature and pressure conditions, must
be taken into account.
SAMSON's After-sales Service department
can support you in drawing up an inspection
and test plan for your plant.
Note
Tip
8.2 Emergency action
The plant operator is responsible for emer-
gency action to be taken in the plant.
We recommend removing the regulator from
the pipeline before repairing it.
In the event of a regulator malfunction:
1. Close the shut-off valves upstream and
downstream of the regulator to stop the
processmediumfromowingthrough
the regulator.
2. Perform troubleshooting (see sec-
tion8.1).
3. Rectify those malfunctions that can be
remedied based on the instructions pro-
vided here. Contact our after-sales ser-
vice in all other cases.
Putting the valve back into operation after
a malfunction
See the 'Start-up' section.