Contents
Select controller output
Y
Operating direction
Yr
Select the current range of controller output Y with
Y0
Safety output (restart) value
YSt
Limit alarm condition for switching output
Y1
Switching output Y1 as break or make contact
Y1C
Limit alarm condition for switching output
Y2
Switching output Y2 as break and make contact
Y2C
Adaption (self-tuning)
AdP
Enter code numbers
CPA
and
CCO
Code number for servicing
Figure, setpoint ramp
SPr
5. Switching outputs
Y1
and
Y2
5.1 Three-step controller with internal feedback (Y = 1)
5.2 Limit contacts
5.2.1 General definition
5.2.2 Assignment of the limit alarm conditions for switching outputs
Y1
and
Y2
5.2.3 Monitor output signal Y
5.2.4 Pulse-modulated on-off controller output at switching output
Y1
and/or
Y2
5.2.5 On-off pulse-modulated controller output with limit alarm
5.2.6 Two pulse-modulated on-off switching outputs
6. Start-up procedure
EEPROM version
6.1 Configure the different controller outputs
6.1.1 Continuous-action controller (
Y
=
0
)
6.1.2 Three-step controller with internal feedback (
Y
=
1
)
6.1.3 Controlled variable x as recorder input (
Y
=
2
)
6.2 Optimize the control parameters
6.3 Adaption (self-tuning)
6.4 Checklist
Figure depicting front view, see folding page on back cover
Page
20
20
20
21
21
21
21
22
22
22
23
23
24
25
26
26
27
27
28
28
28
29
29
29
29
30
30
31
33
34
36
3
To Next Page
Loading...