Before requesting service, please check the following.
• Is the power cord plugged into the
outlet?
• Connect the power plug to the
outlet.
• Is there static electricity in the air? • Disconnect the power plug and
connect it again.
• Are the speakers and external
components connected properly?
• Is the Mute function on?
• Is the volume set to minimum?
• Connect them correctly.
• Press the
MUTE button to
cancel the function.
• Adjust the volume.
• Is the external component
connected properly?
• Connect it correctly.
• Are the batteries drained?
• Is the distance between remote
control and main unit too great?
• Replace with new batteries.
• Operate at close distance.
• Are the left/right speaker or left/right
input/output cables connected
properly?
• Check the left/right channel and
connect it/them correctly.
• Is FM antenna connected
properly?
• Connect the antenna correctly.
• If the input strength of antenna
signal is weak, install the FM
antenna in a place with good
reception.
• Are the surround speakers
connected properly?
• Is SR (surround) incorrectly set to
NONE in the Speaker Size?
• Is surround mode set to stereo?
• Refer to page 14 to connect
them properly.
• Refer to page 25 to select
SMALL or NONE.
• Is the input signal selected
properly?
• Only 2 channel signal can
select Dolby Pro Logic II mode.
(ex:PCM, 2 channel analog
input signal.)
Other Information
To Next Page
Loading...
