Operation
Turning the TV On and Off
Press the POWERO button on the remote control.
You can also use the POWER (!) button on the front of the panel.
Plug & Play Feature
When the TV is initially powered on, two basic settings proceed automatically and subsequently:
Press the POWERO button on the remote control.
The message "Menu language, Channels and Time will
be set." is displayed.
Press the ENTERG_ button, then "Select the language
of the OSD" menu is automatically displayed.
Press the 4 or !_ buttons to select "Shop" or "Home",
then the ENTERC, -_ button.
We recommend setting the TV to Home mode for the best picture in your
home environment,
:_ Shop mode is only intended for use in retail environments,
>- If the unit is accidentally set to Shop Mode, press and hold the MENU Im
button on the side panel of the TV for five seconds to return to Dynamic
(Home) mode.
Press the ENTER_ button to enter the language.
Press the _1 or t_ button to select language, then the
ENTER C__button.
"Select the antennas to memorize" menu is automatically
displayed.
Press the 4 or _, button to memorize the channels of
the selected connection.
Press the ENTERE_ button to select "Start".
If the antenna is connected toANT 1(AIR), select 'Air" and if it is
connected to ANT 2 (CABLE), select 'Cable".
:_- If both ANT 1 (AIR) and ANT 2 (CABLE) are connected, select 'Air + Cable".
>- In Cable mode, you can select the correct signal source among STD,
HRC, and IRC by pressing the _ or _, button, then press the
ENTER_ button.
Contact your local cable company to identify the type of cable system
that exists in your particular area.
English-15
continued...
To Next Page
Loading...
