Checking the Digital-Signal Strength
Unlike analog channels, which cal] vary in receptien quality frem "snowy" to clear, digital (HDTV) channels have either perfect
receptien quality er you will net receive them at all. Se, unlike analeg channels, you cannot fine tune a digital channel.
You can, hewever, adjust yeur antenna te impreve the receptien el' available digital channels.
Press the MENU button. Press the 4 or _ button to select "Channel",
then press the ENTER C_ button.
Pressthe,,or.-buttontoselect"SignalStrength".thenpressthe
........................................:ENTER _ button.
If the signal strength meter indicates that the signal is weak, physically
adjust your antenna to increase the signal strength.
Continue to adjust the antenna until you find the best position with the
strongest signal.
Select "Return" by pressing the ENTER _ button, to return to the previous
menu. Press the EXIT button to exit.
LNA (Low Noise Amplifier)
It' the TV is eperating in a weak signal area, semetimes the LNA functien can impreve the receptien (a lew noise preamplifier beests
the inceming signal).
Press the MENU button. Press the ,_ or i_ button to select "Channel",
then press the ENTER _ button.
Pressthe-.or,,buttontose.ect",NA",thenpresstheENTER÷button
Press the A or v button to select "On" or "Off', then press the
ENTER _ button.
Select "Return" by pressing the _ or '_ button, then press the ENTER
button to return to the previous menu. Press the EXIT button to exit.
>,- The LNA setting must be made separately for each channel.
:_ If the picture is noisy with the LNA set to On, select Off.
English-39
To Next Page
Loading...
