English - 23
Using Automatic Picture Settings
Your TV has Three automatic picture settings ("Dynamic", "Standard" and "Movie") that are preset at the factory.
You can activate either Dynamic, Standard, Movie by making a selection from the menu.
1. Press the M
ENU button to display the menu.
Press the ENTER
button, to select “Picture”.
2. Press the E
NTER
button to select "Mode".
Press the ▲ or ▼ button to select the "Dynamic", "Standard", "Movie" picture
setting. Press the ENTER
button.
Choose Dynamic to increase the clarity and sharpness of the picture.
Choose Standard for the standard factory settings.
Choose M
ovie for a natural Image without picture enhancements.
3. Press the ▲ or ▼ button to select "Contrast", "Brightness", "Sharpness",
"Color" or "Tint(G/R)", then press the ENTER
button.
4. Press the ◄ or ► button to decrease or increase the value of a particular item.
For example, if you select "Contrast", pressing the ► button increases it.
Press the ENTER
button.
Press the EXIT
button to exit.
When you make changes to "Contrast", "Brightness", "Sharpness",
"Color" or "Tint(G/R)", the OSD will be adjusted accordingly.
"Tint" is not activated in PAL-M Signal and PC modes.
Each adjusted setting will be stored separately according to its input mode.
Press the P
.MODE button on the remote control repeatedly to select the desired
picture mode.
Picture Control
Mode
:
Dynamic
►
Contrast : 100
Brightness : 45
Sharpness : 75
Color : 55
Tint (G/R) : G50/R50
Color Tone : Cool1
Backlight : 10
Picture Picture
Mode
:
Dynamic
►
Contrast : 100
Brightness : 45
Sharpness : 75
Color : 55
Tint (G/R) : G50/R50
Color Tone : Cool1
Backlight : 10
Dynamic
Standard
Movie
Mode : Dynamic
Contrast : 100
►
Brightness : 45
Sharpness : 75
Color : 55
Tint (G/R) : G50/R50
Color Tone : Cool1
Backlight : 10
Detailed Settings
Picture
100Contrast
Enter Return
AdjustMove
To Next Page
Loading...
