English - 48
LNA (Low Noise Amplier)
1. Press the MENU button to display the menu.
Press the ▲ or ▼ button to select “Channel”, then press the ENTER button.
2. Press the ▲ or ▼ button to select “LNA”, then press the E
NTER
button.
3. Press the ▲ or ▼ button to select “On”, then press the E
NTER button.
Press the EXIT button to exit.
LNA functions only when antenna is set to Air or Cable.
The LNA setting must be made separately for each channel.
If the picture is noisy with the LNA set to "On", select "Off".
If the TV is operating in a weak-signal area, sometimes the LNA function can improve the reception (a low-noise preamplier
boosts the incoming signal).
Channel
Fine Tune
Signal Strength
LNA : On ►
Color System : Auto
Channel
Fine Tune
Signal Strength
LNA : On ►
Color System : Auto
Off
On
Channel
Signal Strength
LNA : On
Color System : Auto ►
Channel
Signal Strength
LNA : On
Color System : Auto ►
Auto
PAL-M
PAL-N
NTSC
Selecting the Color System
1. Press the MENU button to display the menu.
Press the ▲ or ▼ button to select “Channel”, then press the ENTER button.
2. Press the ▲ or ▼ button to select “Color System”, then press the E
NTER
button.
3.
Press the ▲ or ▼ button to select "Auto", "PAL-M", "PAL-N" or "NTSC", then
press the E
NTER button.
Press the EXIT
button to exit.
Auto: Automatically sets a color system suitable for the input video signals.
PAL-M: Outputs video signals in the PAL-M type color system.
PAL
-N: Outputs video signals in the PAL-N type color system.
NT
SC: Outputs video signals in the NTSC type color system.
This function is available only in analog TV mode.
Selects a color system suitable for the input video signals.
To Next Page
Loading...
