English
9-28
● Sequence Time
- When connecting with SHR-2160/2162/2080/2082 in the monitoring mode, set
the auto sequence time if the auto sequence is set. The time can be set from 10
to 20 minutes.
● OSD Display
- Sets if OSD shall be displayed on each channel of Smart Viewer.
- Whether you check “Enable” or not, OSD will appear or not.
However, Audio icon, PTZ icon, REC icon, and Alarm/Motion event icon will not
be affected by the OSD condition.
● Callback Connection
- Sets the port for Callback connection.
● Auto Connection
- Sets if the smart viewer is automatically connected to
SHR-2160/2162/2080/2082 or site at the initial operation.
- If you check “Auto Connection Enable”, the names of SHR-2160/2162/2080/2082
and Site currently registered at the DVR/Site list will be displayed in the following
list. If you select one from the list, the smart viewer will connect to the selected
SHR-2160/2162/2080/2082 or Site when it operates later.
● Language
- Sets the language used in the SmartViewer.
SHR-2160/2162/2080/2082-E-3 10/18/07 4:49 PM Page 9-28
To Next Page
Loading...
