English
SHR-2160/2162/2080/2082 USER’S MANUAL
5-27
6
Schedule
This setup selects a time to record automatically.
Selection by the day or by the time is available.
The default value is set to “Event Record”.
●
Press “CH >” copies the value of Channel 1 to all the channels.
●
The horizontal axis numbered from 0 to 23 represents the time value.
The vertical axis numbered from S to H represents the day value. (H : Holiday)
Selection by the day or by the time is available.
●
Pressing “ALL” converts the overall setting of the selection window into
Continuous
➝ Event Record ➝ Schedule / Event Record.
●
Record Schedule
Recording starts automatically on the preset time.
Recording follows the condition that set in 5-18. Record Mode.
☛
Refer to 7-2 Record Schedule.
●
Event Recording
Recording starts automatically when an event (Alarm/Motion Detection / Video
Loss) occurs within a setup time.
Recording follows the condition that set in 5-20.Event Record Mode setup.
☛
Refer to 7-3 Event Recording.
●
Scheduled recording is indicted by yellow, event recording by blue,
scheduled/event recording by red, and non-designated recording by gray.
●
Schedule / Event Record
On occurrence of Event, Continuous Recording is replaced with Event Recording Mode.
●
Holiday
If you press “Holiday”, a calendar pops up and you are able to designate holidays.
Move to a date and press “Enter” to complete designation.
Press “Enter” once more to cancel designation.
“H” at the bottom of the table means a holiday.
SHR-2160/2162/2080/2082-E-1 10/19/07 9:36 AM Page 5-27
To Next Page
Loading...
