2-16
English
8. Check if there is any problem with connector or wiring inside of the product for connecting
and mounting then close the cover.
9. Tighten cover mounting screws. (The left and right side each has 5 spots and back side ha
s1 spot)
Caution
Caution
1. When mounting an additional HDD, the primary's master has to be mounted.
In general, HDD should be installed as the primary master of IDE, and the CD-RW drive
should be installed as the secondary master of IDE.
When adding one - Primary slave (add one additionally on the top of the bracket that has a
built-in HDD when coming out of factory.)
When adding two - Secondary Slave (mount to the upper bracket of the built-in CD-RW.)
2. Mount the HDD you want to add after setting the master/slave jumpers in the proper order.
Primary HDD
Secondary HDD
SHR-2160/2162/2080/2082-E-0 10/18/07 3:55 PM Page 2-16
To Next Page
Loading...
