4. Close the cover of the Auto Iris Lens Connector Plug.
Remove the camera's Front Protective Cover, and attach
the auto iris lens to the camera by turning the lens
clockwise.
5. Insert the connector plug of the auto iris lens cable into the
Auto Iris Lens Connector on the side of the camera. (This
product is compatible with the SLA-2882.)
6. Use the Auto Iris Lens Switch on the back of the camera to select DC or VIDEO depending
on the type of your auto iris lens.
Pin 3
Pin 1
Connector
Lens Cable
Pin 4
Pin 2
Lens
Type DC VIDEO
Pin 1 Damping - Red (Power)
Pin 2 Damping + NC
Pin 3 Drive + White (Video Signal)
Pin 4 Drive - Black (Ground)
Chapter 3. Installing Camera & Network Setup
Remove the camera’s Front Protective Cover, and attach the C-Mount lens to the camera by
turning the lens clockwise.
1. Remove the camera’s Front Protective Cover and C-Mount Adapter.
2. Attach the CS-Mount lens by turning the lens clockwise.
■
When Using a C-Mount Lens
■
When Using a CS-Mount Lens
C-Mount Adapter
C-Mount Adapter
CS-Mount Adapter
Protection Cap
To Next Page
Loading...
