· Depending on the type of a video, enter an address as from the examples in the
following chart, and then click Play. When using the default RTSP port number, 554, you
may skip entering the port number.
Chapter 4. Using Web Viewer
Address Streaming Engine Configuration
rtsp://<IP>:<SERVICE PORT>/mpeg4unicast RTSP/TCP, RTP/UDP Use
rtsp://<IP>:<SERVICE PORT>/mpeg4multicast RTSP/Multicast Use
• New settings are saved only if you click the button at the bottom of the screen. The
button cancels new settings.
•
When selecting a mode at Video Stream on the Video / Audio page, the 960P mode saves a video
selection at 960P. 720P saves the area at 720P. (The Enable and MD Sensitivity options, however, are
not affected by the mode.)
Caution
4.2.1.3 Motion Detection
Configure the camera’s Motion Detection operation.
Category Description
Enable Check to enable Motion Detection.
Sensitivity
Select a sensitivity level for motion detection according to the video display
settings. 5 levels are available, and 5 is the most sensitive.
·
: Selected Area,
: Non-Selected Area
Note
·
<IP> : camera IP.
·
<SERVICE PORT> : Service port number(in the Config setup
→
Network).
Note
To Next Page
Loading...
