Factory Default Settings
The following are the factory default settings for the product.
Main Menu Sub Menu Default setting
1 Ch Display On
Flip Image Off
Stretch Image Off
Information On
Save Image Off
Basic Mode
Resolution Main
Compression MPEG - 4
PTZ Mode PTZ Speed 3
Relay Off
Main Menu Sub Menu Default setting
Video/Audio
Video
Mode 960P
Default Display
Stream
Main Stream
Stream
Main Stream
Resolution MEGA
Frame rate(MPEG-4) 10
Frame rate(M-JPEG) 5
Quality High
Sub Stream
Resolution CIF(Fixed)
Frame rate(MPEG-4) 20
Frame rate(M-JPEG) 5
Quality High
Audio-In Use
Audio-Out Use
Max User Connection 5
Mic. Sensitivity Low
Streaming
Continuous Jpeg Image
Transmission to FTP Server
(Jpeg CIFs.)
Use No Use
Frame Rate 1fps
Server Name server_name
Server Port 21
Home Directory /
User ID user_id
User Password
Streaming Streaming Engine
Service
RTSP/TCP No Use
RTP/UDP No Use
RTP/Multicast No Use
RTP/Multicast IP 224.0.1.1
RTP/Multicast Port 9000
Unicast Image Resolution Main
RTSP Standard Port(554) Use
Motion
Detection
Enable No use
Sensitivity 3
Privacy
Enable No Use
Blending Level 5
Camera
1. LENS LENS SETUP
DC/VIDEO
Brightness Level 30
Focus ADJ No Use
Shutter Level 1/60
2. EXPOSURE
SHUTTER SETUP A.FLK.60Hz
GAIN SETUP Low
SENSUP SETUP
Enable Use
Sens-Up Level X2
3. WHITE BALANCE
WHITE BALENCE SETUP ATW
RED Level 200
BLUE Level 35
4. DAYNIGHT DAY & NIGHT SETUP AUTO
5. IMAGE ADJ
FLIP SETUP On
MIRROR SETUP On
SHARPNESS SETUP 3
6. BLC BLC SETUP OFF
7. RESET OFF
Record Recording Setup
Target Stream
Main Stream
(MPEG-4)
Pre Alarm 1 sec
Post Alarm 5 sec
M-JPEG Recording
Frame Rate
N/A
MPEG-4 Recording Option 1 fps
Overwrite No Use
Warning
Message
No Use
Replay /
Backup
Replay / Backup Event Type ALL
Monitoring
Video Setup
To Next Page
Loading...
