• Please make sure that your lens connector has the dimensions illustrated below. If you use a lens
whose connector does not fit the camera, you may damage the
camera or fail to attach the lens securely.
• If your lens is too heavy, your camera will be out of balance and may
be damaged. Please use a lens that does not weigh more than 450g
(15.87 oz.)
• The recommended mode for the Automatic Light Control (ALC) for
an auto iris lens is Av Mode. Using Pk mode may cause image
brightness to constantly change.
Caution
C-Mount Lens: 10mm or smaller
CS-Mount Lens: 5mm or smaller
3.2. Connecting Monitor
Connect a cable to the camera’s rear video output terminal and a monitor's video input terminal.
SNC-1300 Network Camera
· The wiring varies depending on your monitor type and peripheral devices; please refer to
the user manual of each device.
· Please keep the monitor and camera turned off while connecting them.
· As shown in the picture above, set the 75Ω/ Hi-Z switch of each device to Hi-Z for the
middle video receiver and to 75Ω for the end device.
• This product is a network camera that transfers video over a network; the video output terminal is used
to set the imaging range of the camera upon the installation.
• Please make sure that the video output terminal of this product is not connected to any recording
equipment as this can cause problems.
Caution
3.3. Power Input
The SNC-1300 requires an adapter with a voltage of at least AC 24V/1A or DC12V/2A. Make
sure to use an appropriate adapter for the camera.
■
AC/DC Compatible
Chapter 3. Installing Camera & Network Setup
Intermediate
End monitor
To Next Page
Loading...
