◇Digital Out(Relay/Alarm) Setup
Category Description
Relay
Select a digital output for certain events: the connected sensor (Sensor1) or
motion detection (MD) is activated.
Duration
Select a duration to activate a relay; it starts when the sensor detects an
event and ends when the relay is disabled. (1, 2, 3, 4, 5, 30 sec, 1, 2, 3, 5
min, and always)
FTP
Check to transfer the information for certain events to your FTP server: when
the connected sensor (Sensor1) or motion detection (MD) is activated.
E-mail
Check to send out the information for certain events via email: when the
connected sensor (Sensor1) or motion detection (MD) is activated.
Recording
Check to send out the information for certain events via email: when the
connected sensor (Sensor1) or motion detection (MD) is activated.
• New settings are saved only if you click the button at the bottom of the screen. The
button cancels new settings.
• These settings do not apply to the Continuous Jpeg Image Transmission to FTP Server option at the
Video Setup → Streaming menu.
Caution
Caution
Chapter 4. Using Web Viewer
4.2.3.4. E-mail-FTP (Alarm)
Enter the information for your FTP server and email address to transfer data when the alarm
activates.
■E-mail / FTP Setup
Enter the information for your FTP server and email address to transfer data when the alarm
activates.
Category Description
FTP
Server Name Enter the domain name or IP address of your FTP server.
Server Port Enter the Port Number of your FTP server.
Home Directory Enter a home directory in the FTP server to save data.
User ID Enter an ID to log in to the FTP server.
User Password Enter an password to log in to the FTP server.
To Next Page
Loading...
