Category Minimum Requirements Recommended Requirements
CPU Intel Core 2 Duo E4300 or better Intel Core 2 Duo E7400 or better
Main Memory 1GB or more 2GB or more
Video Memory 256M or more 512MB or more
Display 1600 X 1200 (w/ 32-bit color) or higher / OpenGL compatible
Hard Disk 80GB or more
Operating System Windows 2000 SP4 / Windows XP Professional / Window Vista
Network 10/100 Base-T Ethernet
DirectX 9.0 or higher
2.3. PC Requirements
⓮
ETHERNET : Connect to a 10/100 Mbps Ethernet network by using a standard RJ-45
connector. You can also use this terminal for PoE (IEEE 802.3af) to supply power to the
camera. The orange LED starts blinking when the camera is successfully connected to a
network and starts transferring data.
⓯
RESET LED :
When pressing the reset switch for longer than 5 seconds, this green LED starts blinking
as the camera resets to its factory defaults.
⓰
POWER LED : This LED turns on when the camera is turned on.
⓱
NT/PAL : Use this switch to optimize your monitor’s screen between NTSC and PAL mode.
⓲
Power : Connect the camera’s default power adapter here.
⓳
GROUND : Use this terminal to ground the camera to external devices.
• Connecting the SNC-1300 network camera to a PoE device may transfer a higher voltage to the
camera; please contact your vender for assistance when installing and uninstalling the camera.
Caution
Chapter 2. Product Information
3.1. Installing Lens
Lenses are sold separately; an auto iris lens, CS-mount lens, or C-mount lens can be used
with this product.
• To take full advantage of this product, it is recommended that you use an auto iris lens with DC drive.
• Keep the lens surface free of pollutants such as dirt or fingerprints, since lens contamination causes
degradation in picture quality.
• Lenses other than dedicated megapixel lenses may cause degradation in picture quality.
Caution
1. Strip the coating from the end of the auto iris lens cable for approximately 8 mm.
2. Strip the coating from the insulated conductor of lens cable for approximately 2mm.
3. Remove the cover from the Auto Iris Lens Connector Plug, and solder the lens cable to the
connector plate of the connector plug.
■
When Using an Auto Iris Lens
Approx. 8mm
Approx. 2mm
(1/16 inch)
Chapter 3. Installing Camera & Network Setup
• Connected length is 30m or less.
Caution
⓭
ALARM :
Alarm Input (I) : Used to connect an alarm input signal such as infrared or thermal sensors.
Alarm Output (O) : Used to connect an alarm output signal such as a flash light or siren.
To Next Page
Loading...
