3.5. Network Configuration & Connection via Website
Use this method if you are installing only one SNC-1300 network camera.
1. Connect the SNC-1300 network camera and your computer using a cross cable.
For the network settings, you must register an internal IP of your computer.
In your computer, click Start
→
Control Panel
→
Network Connections
→
Local Area Connection
→
Properties.
· Next select the Internet Protocol (TCP/IP) and click the "Properties" button
below, then press the "Advanced…" to set advanced options for your product.
· Add ∙ 192.168.1.XXX as the internal IP of your computer. (XXX: 0 ~ 255)
Note
Chapter 3. Installing Camera & Network Setup
• A condenser mic is recommended for the AUDIO IN terminal.
• A speaker with a self-contained amp is recommended for the AUDIO OUT terminal.
Caution
To Next Page
Loading...
