CompactFlash Memory Card Product Manual
SanDisk CompactFlash Memory Card Product Manual © 1998 SANDISK CORPORATION 87
Attribute
Offset
Data 7 6 5 4 3 2 1 0 Description of Contents CIS Function
078h 22h CISTPL_FUNCE Function Extension tuple Tuple Code
07Ah 03h This tuple has 3 info bytes Link Length
07Ch 02h Disk Function Extension Tuple
Type
Basic PCMCIA-ATA
Extension tuple
Extension Tuple Type for Disk
07Eh 0Ch R
0
R
0
R
0
R
0
U
1
S
1
V
0
No Vpp, Silicon Drive with
Unique Manufacturer / Serial
Number combined string
V=0:No Vpp Required
V=1:Vpp on Modify Media
V=2:Vpp on any operation
V=3:Vpp continuous
S:Silicon, else Rotating
U:ID Drive Mfg/SN Unique
Basic ATA Option Parameters
080h 0Fh R
0
I
0
E
0
N
0
P3
1
P2
1
P1
1
P0
1
All power down modes and
power commands are not
needed to minimize power.
P0:Sleep Mode Supported
P1:Standby Mode Supported
P2:Idle Mode Supported
P3:Drive Auto Power Control
N:Some Config Excludes 3X7
E:Index Bit is Emulated
I:Twin -IOis16 Data Reg Only
Extended ATA Option
Parameters
082h 1Ah CISTPL_CONF Configuration Tuple Tuple Code
084h 05h Link Length is 5 bytes Link to next tuple
086h 01h RFS
00
RMS
00
RAS
01
Size of Reserved Field is 0
bytes, Size of Register Mask
is 1 Byte, Size of Config Base
Address is 2 bytes
RFS:Bytes in Reserved Field
RMS:Bytes in Reg Mask-1
RAS:Bytes in Base Addr-1
Size of fields byte (TPCC_SZ)
088h 07h TPCC_LAST Entry with Config Index of
07h is final entry in table
Last entry of configuration
table
08Ah 00h TPCC_RADR (lsb) Configuration Registers are Location of
08Ch 02h TPCC_RADR (msb)
located at 200h in Reg
Space.
Config Registers
08Eh 0Fh R
0
R
0
R
0
R
0
S
1
P
1
C
1
I
1
First 4 Configuration
Registers are present
I:Configuration Index
C:Configuration and Status
P:Pin Replacement
S:Socket and Copy
R:Reserved for future use
TPCC_RMSK
To Next Page
Loading...
Need help?
General