To ensure that the meter is used safely, Be sure to observe the
instruction when using the instrument.
1. Never use meter on the electric circuit that exceed 6 kVA.
2. Pay special attention when measuring the voltage of AC 33 Vrms
(46.7 Vpeak) or DC 70 V or more to avoid injury.
3. Never apply an input signals exceeding the maximum rating
input value.
4. Never use meter for measuring the line connected with
equipment (i.e. motors) that generates induced or surge
voltage since it may exceed the maximum allowable voltage.
This instruction manual explains how to use your multimeter
CD732 safely. Before use, please read this manual thoroughly.
After reading it, keep it together with the product for reference to it
when necessary.
Using this product in ways not specified in this manual may
damage its protection function.
The instruction given under the heading
" WARNING" " CAUTION"
must be followed to prevent accidental burn or electrical shock.
1-1 Explanation of Warning Symbols
The meaning of the symbols used in this manual and attached to
the product is as follows.
: Very important instruction for safe use.
・The warning messages are intended to prevent accidents to
operating personnel such as burn and electrical shock.
・The caution messages are intended to prevent damage to the
instrument.
: Dangerous voltage (Take care not to get an electric shock
involtage measurement.)
: DC : AC : Resistance
: Buzzer : Diode : Line frequency
: Duty ratio : Capacitor : Plus
: Minus : Double insulation
: Fuse : Ground
1-2 Warning Instruction for safe use
Ω
Duty
–
+
~
【1】
SAFETY PRECAUTIONS : Before use, read the following safety precautions
WARNING
–
32
–
To Next Page
Loading...
