Sanyo DSR-2108 - B Setting the Display

Remote Setup
67
To set the live video display conditions.
b Common settings (General)
These settings apply to all channels.
1 OSD
Sets whether to display or not date and time as well as
channel number on the screen.
•ON: Display
• OFF: Do not display
2 Sequence
Setting for automatically switching the displayed video.
Displays the video of the connected cameras on a
single-screen or quad-screen display sequentially, in the
order of channel numbers.
•ON: Automatic sequencing enabled
• OFF: Automatic sequencing disabled
3 Seq-Dwell Time
Sets the interval (1 - 60 SECONDS) for automatically
switching the screens.
4 Event Beep
Setting for sounding an alarm in the event of an alarm.
•ON: Alarm sound enabled
• OFF: Alarm sound disabled
5 OSD Contrast
Adjusts the character contrast on the screen.
b Channel-specific settings
These settings apply to the specified channel only.
1 Channel designation (CH1 - CH16)
☞ In DSR-2108, CH1 - CH8.
2 Display
Sets whether to display or not video from the channel on
the monitor.
•ON: Display
•OFF: Do not display
3 Video image adjustment
• Brightness: Adjusts the brightness.
• Contrast: Adjusts the contrast.
•Hue: Adjusts the hue.
• Saturation: Adjusts the saturation.
B
Setting the Display
1
3
5
24
1
2
3
L8HBT_WA(DSR-2116_2108)(GB).book 67 ページ ２００９年５月２７日 水曜日 午後４時５０分