Remote Setup
74
To set information about the DVR network.
b Network settings
1 Port
When connecting multiple DVRs to the network, set a
unique port number to each DVR.
2 Client Access
To operate via network, make sure the checkbox is
checked.
3 Band Width Saving
To limit the network bandwidth, check the checkbox.
4 Address settings
Input necessary information depending on the selected
[Network Type].
• If "LAN" is selected:
The address setting mode is manual.
Input IP, Gateway, Subnet Mask, and DNS Server IP.
• If "DHCP" is selected:
The address setting mode is automatic.
Addresses and other information do not need to be set.
• If "ADSL" is selected:
Input the login ID and Password.
b DDNS settings
When using Sanyo's DDNS service, select "SANYO" and
input the registered domain name.
Memo: • Refer to P45 for details on how to register the
domain name.
• When using other company's DDNS service,
contact the dealership where this unit was
purchased or a "Repair Service Center".
I
Setting the Network
The DVR will be forcibly restarted if a value on this
screen is changed.
1
4
23
L8HBT_WA(DSR-2116_2108)(GB).book 74 ページ ２００９年５月２７日 水曜日 午後４時５０分
To Next Page
Loading...
