Sanyo PLC-HF15000L

33
The input source changes each time you press the INPUT button on the side control as follows:
Input 1→Input 2→ ...
Before using the INPUT button on the side control or the remote control, you must select a correct input source
by On-Screen Menu and the latest input source will be displayed.
Press the INPUT 1, INPUT 2, INPUT 3 or INPUT 4 button on the remote control. The input source appears on
the screen as you press each button. Select the connected input source.
INPUT 1 button
Input 1
RGB (PC analog)
RGB (Scart)
RGB(PC digital)
INPUT 2 button
Input 2
RGB
Y,Pb/Cb,Pr/Cr
Video
Side Control
INPUT button
Direct Operation
Remote Control Operation
Side Control
INPUT 1/2/3/4
buttons
Remote Control
S-video
RGB(AV HDCP)
HDMI
Input Selection
Note:
•“Input 3” and/or “Input 4” are selectable only when interface
board(s) are connected to either or both of the slots.