69
This function allows you to change the presentation of the P-
timer and execute it.
Select one of the following options:
Count up............ The P-timer display 000:00 appears on
the screen and the count starts (000:00–
180:00)
Count down....... The time set in the Timer setting appears
on the screen and the countdown starts.
Timer ................. Use the Point ! buttons to set the
Timer (1–180 Min). Only set to Count
down, Timer is active. Factory default
value is 10 Min.
Start................... Executes the count up or count down
function. Press the SELECT button at
Start, Start changes to Stop in the Screen
Menu. At that time, press the SELECT
button at Stop to stop Count up or Count
down, and Stop changes to Restart in the
Screen Menu. Press the SELECT button
at Restart to resume Count up or Count
down.
Reset ................. Resets the P-timer values. Press the
SELECT button at Reset to return to the
following value;
Count up ... "000:00"
Count down ... Timer that you set
Exit..................... To exit the P-timer operation.
Stop or Cancel the P-timer via Remote Control
To stop the P-timer, press the P-TIMER button.
To cancel the P-timer, press and hold the P-TIMER button for
a few seconds.
P-TIMER
This function returns all setting values except for User
logo, PIN code lock, Logo PIN code lock, Filter counter and
Network setting to the factory default settings.
Various test pattern are available for use when setting up the
projector.
Settings
P-timer
Test pattern
Factory default
To Next Page
Loading...
Need help?
General
