Sanyo PLC-WTC500L - Page 24

-24-
Mechanical Disassembly
3-1. Audio, Panel Temp, Rear Junction, R/C Rear Board re-
moval
1. Remove 2 screws-A(T3x8) and take off the Audio Board upward.
2. Unhook and slide the Panel Temp Sensor Board to remove.
3. Remove 2 screws-B (M3x6) and take off the Rear Junction Board.
4. Remove 1 screw-C (M3x6) and take off the R/C Rear Board.
5. Loosen 1 hex screw-D (M2.5) and take the Shutter Assy upward off.
Shutter assy
Panel temp
Sensor board
Rear junction
board
Audio board
R/C rear board
A
B
B
C
D