Setting
Blue back
Press the Point ◄► buttons to switch On/Off. When this
function is "On", a blue image is displayed while the input
signal is not detected.
Keystone
This function corrects distortion of a projected image.
Select either Store or Reset with the Point ◄► buttons,
and then press the SELECT button. The keystone dialog
box appears. Correct keystone with the Point ▲▼ buttons.
see page 22.
Store
. . . . store the keystone correction even when the
AC power cord is unplugged.
Reset
. . . . reset the keystone correction when the AC
power cord is unplugged.
Display
Press the Point ◄► buttons to switch Off/Countdown off/
On. This function decides to display On-Screen Displays.
Off. . . . . . . . . . . . . Do not show On-Screen Displays,
except.
Countdown off . . . Show the input image instead of
the countdown when turning on the
projector. Use this function when you
want to project the image as early as
possible even when the lamp is not
bright enough.
On. . . . . . . . . . . . . Show all the On-Screen Displays.
Use this function when you want
to project images after the lamp
becomes bright enough. Factory
default setting is this mode.
● On-Screen Menu
● "Power off?" message
● P-Timer
● "No signal" message for Power management item.
(p.50)
● "Please wait ..." for Auto PC adjustment.
● Arrows for panning mode in the Screen Menu. (p.34)
Setting
To Next Page
Loading...
