16
The eight different remote control codes (Code 1–Code 8) are assigned to this projector. Switching the remote control
codes prevents interference from other remote controls when several projectors or video equipment next to each other are
operated at the same time. Change the remote control code for the projector first before changing that for the remote control.
See “Remote control” in the Setting Menu on page 56.
Press and hold the MENU and a number button (1–8) for
more than five seconds to switch between the codes.
1
To initialize the remote control code, slide the RESET/ ON/
ALL-OFF switch to “RESET”, and then to “ON”. The initial
code is set to Code 1.
2
MENU button
Number buttons
(1-8)
RESET/ON/ALL
OFF Switch
Press and hold the MENU and a number button
(1-8) that corresponds to the remote control code
for more than five seconds to switch between the
codes.
Part Names and Functions
Remote Control Code
Adjustable Feet
Projection angle can be adjusted up to 4.0 degrees with the
adjustable feet.
Rotate the adjustable feet and tilt the projector to the proper height;
to raise the projector, rotate the both feet clockwise.
To lower the projector or to retract the adjustable feet, rotate the
both feet counterclockwise.
To correct keystone distortion, press the KEYSTONE button on the
remote control or select Keystone from the menu (see pages 14,
31, 44, 50).
Adjustable Feet
To Next Page
Loading...
Need help?
General
Weight and Dimensions
