Sanyo PLC-XM100 - Menu Bar

26
Basic Operation
For detailed functions of each menu, see “Menu Tree” on pages 73-75.
M
N
O
P
Q
R
S
T
Main Menu
Sub-Menu
U
V
O Image select
For computer source, used to select an image level among Standard, Real, and Image 1-10 (p.40).
For Video source, used to select an image level among Standard, Cinema, and Image 1-10 (p.46).
P
Image adjust
For computer source, used to adjust the computer image. [Contrast/Brightness/Color temp./White balance (R/G/B)/
Offset(R/G/B)/Sharpness/Gamma/Reset/Store] (pp.41-42).
For Video source,
used to adjust the video image. [Contrast/Brightness/Color/Tint/Color temp./White balance (R/G/
B)/Offset (R/G/B)/Sharpness/Gamma/Noise Reduction/Progressive/Reset/Store] (pp.47-48).
N PC adjust
Used to adjust the parameters to match with the input signal format (pp.37-39).
Q
Screen
For computer source, used to adjust the size of the image. [Normal/True/Wide/Full/Custom/Digital zoom +/-/Keystone/
Ceiling/Rear/Reset] (pp.42-44).
For Video source, used to adjust the size of the image. [Normal/Wide/Custom/Keystone/Ceiling/Rear/Reset] (pp. 49-
50).
M Input
Used to select an input source (Input 1, Input 2, Input 3 or Network) (p.33).
Note: Network will be not displayed when optional PJ-Net Organizer is not attached.
R Sound
Used to adjust the volume or mute the sound (p.28).
T Information
Display the input source information: Input, H-sync freq., V-sync freq., Screen, Language, Lamp status, Lamp counter,
Filter counter, Power management, Key lock, PIN code lock, Shutter management, Simple mode, Remote control,
and SERIAL NO. (p.29).
V Guide
The key operation is displayed.
S
Setting
Used to set the projector’s operating configurations (pp.51-62).
U Network
See the owner’s manual of “Network Set-up and Operation”.
Menu Bar