Sanyo PLC-XM100 - Page 48

48
8VHWKH3RLQWŻŹEXWWRQVWRDGMXVWWKHJDPPDYDOXHWRREWDLQD
better balance of contrast (from 0 to 15).
3UHVVWKH3RLQWŻEXWWRQWRGHFUHDVHWKHVKDUSQHVVRIWKHLPDJH
SUHVVWKH3RLQWŹEXWWRQWRLQFUHDVHWKHVKDUSQHVVRIWKHLPDJH
(from 0 to 31).
An interlaced video signal can be displayed in progressive mode.
3UHVVWKH3RLQWŻŹEXWWRQVWRFKDQJHWKHSURJUHVVLYHVFDQPRGH
Off ........... Progressive scan mode is Off.
On ........... Progressive scan mode is On.
Film......... For watching a film. With this function, the projector
reproduces pictures faithful to the original film quality.
Noise interference on the screen can be reduced. Press the Point
ŻŹEXWWRQVWRFKDQJHWKHQRLVHUHGXFWLRQPRGH
Off ........... Noise reduction mode is Off.
On ........... Noise reduction mode is On.
3Note:
• Noise reduction and Progressive cannot be selected when
480p, 575p or 720p is selected (p.45).
•
Noise reduction cannot be selected when 1080p is selected
(p.45).
To reset the adjusted data, select Reset and press the SELECT
button. A confirmation box appears and then select Yes. All
adjustments will return to their previous figures.
Image
To store the adjusted data, select StoreDQGSUHVVWKH3RLQWŹRU
WKH6(/(&7EXWWRQ8VHWKH3RLQWŸźEXWWRQVWRVHOHFWRQHIURP
Images 1 to 10 and press the SELECT button.
A confirmation box appears and then select Yes. Stored data can
be called up by selecting an Image (1-10) in the Image Mode
Selection on page 46.
A confirmation box
appears and then
select Yes.
Store
Video Input
3UHVVWKH3RLQWŻEXWWRQWROLJKWHQUHGJUHHQEOXHWRQHRIWKH
EODFNOHYHORIDQLPDJHSUHVVWKH3RLQWŹEXWWRQWRGHHSHQUHG
green/blue tone of the black level of an image (from 0 to 63).
Offset(Red/Green/Blue)
Sharpness
Gamma
Noise reduction
Progressive
Reset
Store