EasyManuals Logo

Sanyo PLC-XU70 User Manual

Sanyo PLC-XU70
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
12
Part Names and Functions
1
2
3
To insure safe operation, please observe the following precautions:
Use (2) AA or LR6 type alkaline batteries.
Always replace batteries in sets.
Do not use a new battery with a used battery.
Avoid contact with water or liquid.
Do not expose the remote control to moisture or heat.
Do not drop the remote control.
If the battery has leaked on the remote control, carefully wipe the case clean and install new
batteries.
Risk of explosion if a battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions.
Open the battery
compartment lid.
Install new batteries into
the compartment.
Replace the
compartment lid.
Two AA size batteries
For correct polarity (+
and –), be sure battery
terminals are in contact
with pins in the
compartment.
Point the remote control toward the projector
(Infrared Remote Receiver) when pressing any
button. Maximum operating range for the
remote control is about 16.4’ (5m) and 60° in
front of the projector.
Operating Range
30°
30°
Remote Control Battery Installation
16.4’
(5 m)

Table of Contents

Other manuals for Sanyo PLC-XU70

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sanyo PLC-XU70 and is the answer not in the manual?

Sanyo PLC-XU70 Specifications

General IconGeneral
BrandSanyo
ModelPLC-XU70
CategoryProjector
LanguageEnglish

Related product manuals