34
Choose Video by pressing the INPUT button on the top
control or the VIDEO button on the remote control.
Before using these buttons, correct input source should be
selected through menu operation as described below.
Press the MENU button to display the On-Screen
Menu. Press the Point 7 8 buttons to move the red
framed pointer to the Input Menu icon.
Press the Point ed buttons to move the red arrow
pointer to Video and then press the SELECT button to
display the Source Select Menu .
1
2
Move the pointer to
Video and press the
SELECT button.
VIDEO
Move the pointer to the
source that you want to
select and press the
SELECT button.
Source Select Menu (VIDEO)
Input Menu
Move the pointer to the source that you want to select
and then press the SELECT button.
3
When selecting Auto, the projector
automatically detects incoming video signal, and
adjusts itself to optimize its performance. The
projector selects connection in the following
order:
1. S-Video
2. Video
Auto
When video input signal is connected to the
VIDEO jack, select Video.
Video
When video input signal is connected to the S-
VIDEO jack, select S-Video.
S-Video
INPUT button
Video
Computer 2
Computer 1
Input Source Selection (Video, S-Video)
Direct Operation
Menu Operation
✔
Note:
When Monitor out is selected in the Terminal function (p44) ,
Computer 2 is not displayed.
✳ See Note at the bottom of this page.
✳
Input Menu icon
Video Input
REMOTE CONTROL
TOP CONTROL
INPUT button
VIDEO button
To Next Page
Loading...
Need help?
General
