10
1. Check that the battery protector is removed and
the battery cover is properly closed.
2. Place the pipette into the charging unit. Make
sure that the metal contacts at the rear of the
pipette are properly fitted to the tracks of the
metal contacts in the top of the charging unit.
3. When charging, the battery symbol will be
displayed with the + and – symbols flashing. The
charging time for completely discharged batteries
is 4 hours.
4. When the battery is full the battery symbol
disappears from the display. If display shows
RESET and PRESS TIP, press the tip ejection button
to reset the pipette, the pipette will then be ready
for use.
NOTE: Never reset the pipette with the tip attached
as the attached tip can induce an error in the home
position determination of the piston and tip ejector
collar!
NOTE: When the pipette is not in use it is recommended
to keep the pipette in the charging unit. This ensures
that the battery is kept charged and the pipette is
ready for use.
5.2. Charging Directly
The AC-adaptor supplied with the eLINE® pipette or
single charging stand can be used for the charging of
the eLINE® electronic pipette. The socket for the AC-
adaptor is situated on the back of the pipette.
1. Before connecting the AC-adaptor to the electrical
outlet, check that its voltage settings corresponds
to the voltage settings of your mains electrical
outlet.
2. Check that the battery protector is removed and
the battery cover is properly closed.
3. Connect the AC-adaptor to the mains electrical
outlet as well as to the socket at the back of the
pipette.
4. The charging time is 12 hours for a completely
discharged battery.
To Next Page
Loading...
