Sartorius MA160 - Interface Specification

66
USB Port
Operating Instructions Moisture Analyzer MA160
Connection with Sartorius Lab Printer YDP30, YDP40
2)
Printer YDP30,
YDP40
Off
Mini-A Type-B
USB Device
(Slave)
Printer equipment
supplied
t Connect the Sartorius printer with the power disconnected to the moisture
analyzer via the supplied USB connection cable.
y The moisture analyzer detects the printer automatically. No settings need to be
changed.
Connection for 9-pin RS-232 Configuration
3)
Printer YDP20-0CE
USB-RS 232 SBI
Off
Mini-A
RS 232
9-pin
Sartorius order no.:
YCC03-D09
Serial device
with 9-pin
SUB-D plug
t Connect the peripheral device to the moisture analyzer using the Sartorius
YCC03-D09 connection cable (RS-232, 9-pin, PC-compliant assignment).
t To configure the desired settings, see chapter “System Settings (Setup Menu),
section “USB Port.”
Interface Specification
Data Output
The print command can be triggered by selecting a.
Data Output Formats
Values are always output with an ID; if more than 22 parameters are set, the values
are printed on two lines. Intermediate values are also output in other formats;
intermediate values are always printed on one line.
You can activate the printout in the Printout menu [see section “Printout” in
chapter “System Settings (Setup Menu)”] and select whether values only or values
and intermediate values are printed.
Example: Output of Intermediate Value 02:00 8.16% M