8
Commissioning
Operating Instructions Moisture Analyzer MA160
Commissioning
Unpacking and Equipment Supplied
t Open the packaging, making sure to remove all parts carefully.
t After unpacking the analyzer, check it immediately for any external damage.
– If you detect any damage, proceed as directed in “Care and Maintenance.”
– Save the box and all parts of the packaging for any future transport.
During shipment, please do not leave cables plugged in!
The following parts are included in the equipment supplied:
– Moisture analyzer
– Country-specific power cable
– Pan support
– Protective cover for the control panel
– 80 disposable aluminum sample pans
– Sample forceps
– 40 glass fiber filters (hard quality)
– 3 ReproEasy pads
– Operating Instructions
Choosing a Location
t Select the proper setup location:
An optimal location guarantees accuracy and reliability. Ensure that the following
ambient conditions are met:
– Set up the analyzer on a stable, even surface that is not exposed to vibrations
(e.g., weighing stone).
– Maintain free access to the analyzer at all times.
– Make sure to choose a place where excessive heat cannot build up.
– Leave enough space between it and materials that are affected by heat.
Choose a location that is not subject to the following negative influences:
– Heat (heater or direct sunlight)
– Drafts from open windows, AC systems, and doors
– Extreme vibrations during measurement
– Heavy traffic areas (personnel)
– Extreme humidity
– Electromagnetic fields
Acclimatization
Condensation from humidity can form on the surfaces of a cold device when
it is brought into a warm area. You should therefore let a device that has been
disconnected from its power source acclimatize for approximately 2 hours before
reconnecting it to the power.
To Next Page
Loading...
