74 Cubis MSE Operating Instructions
Data Interfaces
Bluetooth® Interface (optional)
How to assemble the Bluetooth® module is described in the supplied installation
instructions�
In order to transmit data via the Bluetooth module, the interface must first be
configured�
Configuring the Bluetooth® Interface
Step Press key Display
t If necessary, toggle to the menu
1� Accessing the Menu: S Press and hold Applic.
1� Display menu level
2� Select and confirm OPT.MOD Repeatedly press Opt.Mod
S, V
3� Select and confirm the DAT.PROT. submenu S, V DAT.PROT.
The following operating modes are possible for this interface under DAT.PROT.:
– SBI (data exchange with PC or notebook)
– Universal printer
– Laboratory printer: parameters for YDP10BT
– No function (off)
t Select the desired operating type�
Establishing a Radio Connection with the Bluetooth® Printer
t Make sure that the printer to which you wish to connect is ready to operate�
t To establish a connection,
Select the OPT�MOD: FIND submenu� S, V Find
y The balance will now search for the Bluetooth device�
This process may take time� wait
Wait for the next message to appear on the display�
! You can only connect to one Bluetooth printer at a time�
y A message will appear to confirm whether the printer has been found� Ser. no.
Connection established to printer YDP01BT: The serial no� appears 23201234
y As soon as the menu is exited, the connection will be re-established�
The LED on the printer will then illuminate permanently (blue)�
Bluetooth Series No. and Model ID
t If required, you can enter the serial number and device name S, V SER.No.
(only with Bluetooth modules from Version 04-10-01)� S, V Model
To Next Page
Loading...
Need help?
General