To Next Page

To Previous Page

Service Manual Signum

Working with the Service Mode

Additional Menus in the Service Mode

In the Text Menu (Setup)

In consecutive order following the menu items » DATE « and Code » 202122 «

– Service date » S-DATE «

– Memory number » MEM-NO «

– Service technician can enter a minimum load here » SQMIN-S «

– This displays or prints the minimum load » SQMIN «

In the number menu: The setup menu is model-dependent for WP1 (WP-1) and the interfaces COM1 (COM1)

and UniCOM (UNICOM). It has been expanded to allow the following possible settings

for conﬁguring weighing platforms WP-1(WP-1) and WP2(WP-2):

1-9 Calibration/adjustment functions:

1-9-1: Ext. calibration/adjustment with a default weight (service mode not

required)

1-9-3: Ext. calibration/adjustment with a user-deﬁned weight (service mode not

required)

1-9-4: Int. calibration/adjustment (service mode not required)

1-9-6:

Internal linearization (only for WP-2 on COM1 and UniCOM)

1-9-7:

External linearization with user-deﬁned weights

1-9-8: Set preload (service mode not required)

1-9-9: Delete preload (service mode not required)

1-9-10: Key blocked (service mode not required)

1-9-18:

Determine internal weight

Only accessible in the service mode

Sartorius Signum 1 Service Manual

Other manuals for Sartorius Signum 1