16
Service Manual Signum
Working with the Service Mode
– Press the ) key. A blinking cursor is displayed.
– Using the k key, select 2 and press the ) key to confirm. When the cursor
jumps to the second field, enter the next number. Follow these steps to enter
the service code 202122.
Important note:
If you enter a number incorrectly, use the ( key to select the field
you wish to change. Next, press the ) key repeatedly until the cursor
scrolls to the 6
th
place (line 2 blinks).
– Once you have entered the last number, press the ) and ( keys (in this
order) to activate the service mode.
An „S“ in the upper right-hand corner indicates that the service mode is active.
If you wish to exit the service code entry mode, continue pressing the ( key until
CODE reappears on the display.
Please note: The only way to deactivate the service mode is to switch the scale
off and then on again.
Important note: Once service code 202122 has been input, any customer codes that have already
been entered can only be viewed. You can delete or change a customer code
only after entering the general access code 40414243.
disp_202122_d.eps
disp_blin_d.eps
disp_code_s_d.eps
!
To Next Page
Loading...
Need help?
General