Sartorius Signum 2 - Activating the Service Mode

15
Service Manual Signum
Description of the Equipment
Activating the Service Mode
Important note: When performing maintenance on an existing system,
you must access the service mode for linearization, to set or clear a
preload, or to enter the date of service.
– Switch the Signum scale off (press the e).
– Switch the Signum scale back on (press the e). While all segments are
displayed, briefly press the ) key.
APPL is displayed.
– Using the k key, scroll to SETUP.
– Press the ) key. WP-1 is displayed.
– Using the k key, scroll to CODE.
disp_wp-1_d.eps
disp_8888_d.eps
disp_appl_d.eps
disp_setup_d.eps
disp_wp-1_d.eps