39
Service Manual Signum
Replacing Components
AUT24263a.JPG
Closing the Scale
1 Plug the connectors back in.
2 Reassemble the parts of the housing in order.
3 If necessary, be sure to include the all O-rings and gaskets.
4 Replace and tighten the screws (P).
5 Plug the unit back into AC power.
6 Check the scale to ensure that it is functioning properly.
Important note:
Once the scale has been repaired and checked to ensure its proper
functioning, new warranty stickers (seals) must be applied.
To Next Page
Loading...
