Example:
Weighing in 100% of a sample material.
Settings (changes in the factory settings required for this example):
Application parameters: Application: Weighing in percent
Setup: Printout:
PrtProt: 7.6.; then select menu line item of your choice
(see “Configuration” for options)
1 Place empty container on
the platform
)
2 Tare the scale
Note: If the automatic tare
function is enabled, you do
not need to press the ) key
to tare the scale; the tare
weight is saved automatically
when you place the container
on the platform
3 Add reference material in
accordance with reference
percentage
(in this example, 85 g)
O
4 Activate calculation of the
reference weight. The calcula-
tion is based on the active net
weight value and the reference
percentage entered.
Reduce the minimum
load setting.
If the weight is too light, the
error code
Inf 29 is shown in
the main display.
5 Continuing filling the
container until the target
amount is reached
(in this example, 100%)
p
6 Print the result
pRef + 20 % Configured printout:
wRef + 0.085 kg see page 80
G# + 1.080 kg
T + 0.675 kg
N + 0.423 kg
Prc + 100 %
-------------------
63
To Next Page
Loading...
Need help?
General