Sartorius Signum 3 Operating Instruction

Data ID Codes
Signum 3 only
You can assign codes (such as product
name, batch number, etc.) for identifi-
cation of measured values on printouts.
Features
– Assign up to four ID codes.
– Assign both a name and a value
for each ID code.
– The name is left-justified and the
value is right-justified on the printout.
If the entire code is too long for one
line, additional lines are printed.
– Enter ID code names in the
operating menu, under:
Setup
prtprot
: 7.4.
Enter up to 20 characters for the
ID code name. No more than
11 characters are displayed during
input; all 20 characters are printed.
– Enter up to 40 characters for the
value of the ID code. Press the ID key
to activate the input mode.
– You can delete characters from the
ID code by pressing the c key.
– If both the name and value fields are
empty, no ID code is printed.
– In the Setup program, you can
configure when and whether ID codes
are printed (see “Configuring Printouts”
on page for operating menu settings).
Factory settings for the ID code names:
ID1:
ID1
ID2: ID2
ID3: ID3
ID4: ID4
Factory settings for the ID code values:
No default values set.
Operation
48

Sartorius Signum 3 Specifications

General

Brand	Sartorius
Model	Signum 3
Category	Scales
Language	English