Sartorius SIWRDCP - Utility Settings and Operation Modes; Keypad, Display, and Timer Settings; Main Scale, Geographical Data, and Factory Reset

Signum 1-2-3
Settings
37
Setup
utilit
8
Operation
(Display designation of this menu level: 8 )
8. 3. Keypad
8.3.1 * All available
8.3.2 All blocked
8.3.3 Numeric keypad Signum
®
3 only
8.3.4 Toggle weighing platform Signum
®
2 and 3 only
8.3.5 Zero
8.3.6 Tare
8.3.7 FN
8.3.8 isoTEST
8.3.9 Print
8.3.10 x10 Signum
®
2 and 3 only
8.3.11 Toggle gross/net Signum
®
2 and 3 only
8.3.12 CF Signum
®
2 and 3 only
8.3.13 Ref Signum
®
2 and 3 only
8.3.14 OK Signum
®
2 and 3 only
8.3.15 Toggle Signum
®
2 and 3 only
8.3.16 Info Signum
®
2 and 3 only
8.3.17 ’D’ Signum
®
3 only
8.3.18 ID Signum
®
3 only
8.3.19 Mem Signum
®
3 only
8. 7. Automatic shutoff of display and control unit
8.7.1 Automatic shutoff acc. to menu item 8 9.
8.7.2 * No automatic shutoff
8. 8. Display lighting
8.8.1 * On
8.8.2 Off
8.8.3 Automatic shutoff acc. to menu item 8.9
8.9. Timer
8.9.1 * After 1 + 1 minute not in use
(after 1 min.: warning displayed
2
) for 1 minute)
8.9.2 After 2 + 2 minutes not in use
(after 2 min.: warning displayed
2
) for 2 minutes)
8.9.3 After 5 + 5 minutes not in use
(after 5 min.: warning displayed
2
) for 2 minutes)
8.11. Main scale: first platform displayed on start-up
8.11.1 * Weighing platform WP 1
8.11.2 Weighing platform WP 2
8.12. Show geographical data before calibration/adjustment
8.12.1 * No
8.12.2 Yes
9.1. Restore factory settings in numeric operating menu
9.1.1 Yes
9.1.2 * No
1
) Multiple selections possible
2
) Warning information: symbol “W 12" flashing (all simultaneously)