Checkweighing Toward Zero Application
68
Checkweighing Toward Zero Application
Example: 2
Checkweighing samples with a target weight of 1250 g and a tolerance range from -10 g to +30 g (using the factory-set application parameters)
Settings (different from the factory settings):
Setup: Application 2: Checkweighing toward zero (parameter 4. 7. 2)
Setup: Printout, PRTPROT 7.6, then select the menu line items of your choice
O
1.) Begin input of target and
tolerance values
2.) Place a sample with the target
weight (in this example,
1250 g) on the platform
O
3.) Save target value
1240
4.) For Signum
®
3 only:
Enter value for lower limit
(in this example, 1240 kg)
O
5.) Save value for the lower limit
1280
6.) For Signum
®
3 only:
Enter value for the upper limit
(in this example, 1280 kg)
O
Save value for upper limit
7.) Weigh samples
p
8.) Print the results
Note: If automatic printout of
results is enabled, you do not
need to press the p key.
The results are printed
automatically.
Setp + 1.250 kg Target
Min + 1.240 kg Minimum
Max + 1.280 kg Maximum
G# + 1.256 kg Gross Weight
T + 0.000 kg Tare weight
N + 1.256 kg Net Weight
Lim + 0.48 % Percentage of deviation from
target*
W.Diff+ 0.006 kg Absolute deviation from target
-------------------
* When displayed in relation to
target value:
If the weight is lighter than
the target, the display shows:
LL
If the weight is heavier than
the target, the display shows:
HH
To Next Page
Loading...
