Examples of Application Combinations in Signum® 3
79
Example: “Portioning” (counting, checkweighing with totalizing)
Settings (different from the factory settings):
Setup: Application parameters: Application 1: Counting (count)
Setup: Application parameters: Application 2: Checkweighing (check.wg)
Setup: Application parameters: Application 3: Totalizing: Saved value: Net + Calculated (3.23.3)
Setup: Application parameters: Application 3: Totalizing: Autosave: On (3.16.2)
Setup: Application parameters: Application 3: Totalizing: Source of data: Application 2 (3.22.2)
Setup: Printout: PRT PROT 7.8. Printer 1:
“Total printout: Print when FN pressed,” then select the menu line items of your choice (x.xx.x))
e
1.) Switch on the scale and enter settings as above
c
2.) Delete any data from previous operation
3.) Place empty container on the platform.
)
4.) Tare the scale
Note: If the automatic tare function is enabled, you do not need to press the ) key to tare the
platform; the tare weight is saved automatically when you place the container on the platform
5.) Place a number of parts in the container for the reference quantity (in this example, 10 pcs)
O
6.) Start calculation of reference sample weight
To Next Page
Loading...
