Sartorius SIWRDCP - Example: Weighing 100% of Sample Material

Signum 1-2-3
Checkweighing Application O
Weighing in Percent Application
L
64
Example:
Weighing in 100% of a sample material.
Settings (different from the factory settings):
Setup: Application 1: Weighing in Percent
Setup: Printout, PRTPROT 7.6, then select the menu line items of your choice
1.) Place empty container on the
platform
)
2.) Tare the scale
Note: If the automatic tare
function is enabled, you do
not need to press the ) key
to tare the platform; the tare
weight is saved automatically
when you place the container
on the platform.
3.) Add reference material in
accordance with reference
percentage (in this example,
85 g)
O
4.) Begin calculation of reference
weight. The calculation is
based on the active net weight
value and the reference
percentage entered.
If the weight is too light, an
error code is shown in the
main display: Inf 29
Reduce the minimum load
setting
5.) Continue filling the container
until the target amount is
reached (in this example,
100%)
p
6.) Print the results
pRef + 20 % Configured printout:
wRef + 0.085 kg see page 81
G# + 1.080 kg
T + 0.675 kg
N + 0.423 kg
Prc + 100 %
-------------------