Chapter 5 Configuring the PM135 Configuring Communications
78 PM135 Powermeter Series
Figure 5-5: TCP Notification Client Setup Tab
The following table lists available client options.
Table 7: TCP Notification Client Setup Options
Enables operations of the
notification client
The IP address of the notification
server
The TCP service port of the
notification server
The start address of a block
of 16 MODBUS registers for
receiving notification messages
Connections with a remote server are triggered via programmable
setpoints. To send event notifications to a server, configure a setpoint to
respond to desired triggers or to periodic time events and put the
"Notification" action to the setpoint action list (see Configuring
Alarm/Control Setpoints).
See the PM135 Modbus Reference guide for more information on operation
of the notification client and the notification message structure.
To Next Page
Loading...
Need help?
General
