Satel CA-5 - Page 24

8 Jul, 13:26:41
.....
trouble – indicates
detection of technical
trouble in system - to check
press key [7] for 3 sec.
armed
on
– partition armed,
blinking
– exit time delay
in progress.
LCD DISPLAY – date and hour
Status of armed zones:
 - zone OK
¦ - zone violated
 - 2EOL zone tamper violated
a - zone alarm
s - memory of 2EOL zone tamper alarm
b - zone bypassed
alarm
on - site alarm
blinking - alarm memory
[
5] - pressing for 3 sec.
activates alarm
memory viewing
[7] - pressing for 3 sec.
activates current
trouble display
[8] - pressing for 3 sec.
activates/deactivates
chime signaling
[0] - pressing for 3 sec. activates
AUX. ALARM
[#] - pressing for 3 sec.
activates PANIC ALARM
CODE+[#] – arming/disarming,
clearing alarm
[6] - pressing for 3 sec.
activates trouble
memory viewing
[
*
] - pressing for 3 sec. activates
FIRE ALARM
CODE+[
*
] - User Functions:
0. Start DWNL
1. Change code
2. New user
3. Erase user
4. Bypass zone
5. Arm silent
6. Set time
7. MONO outputs
8. BI outputs
9. Power supply reset
10. Events
11. Output test
12. Service access