SATO CL4NX - Page 46

46
8. Conguretheportsettingsandclick[OK].
Ifyouselected[TCP/IP(LAN)]
Note:
• Youcannotsetthesamenameasanexistingportname.
• Thecomputercannotcommunicatewiththedestinationprinterifthe[PrinterNameorIP
Address]and[PortNumber]settingsdonotmatchthoseoftheprinter.
• Click [OK] to check communications using the congured settings. If communications
failed,thefollowingscreenappears.
[Cancel]
Returns to the previous screen. Click this button to change [Printer Name or IP
Address]oranyothersettings.
[Try Again]
Checks communications again.
[Continue]
Does not check communications and proceeds to the next step. Click this button
whenyouwanttocontinuewiththeportsetupwithoutcheckingcommunicationswith
the printer.
• Normally,youdonotneedtochange[PortNumber](thedefaultvalueontheprinteris
also9100).
• Normally,youdonotneedtochangethetimeoutsettings.
• The[AdvancedTCP/IPPortConguration]dialogboxcanbeshownevenafterinstalling
theprinterdriverwiththefollowingprocedure:
a. Open [Devices and Printers], right-click the desired printer, and select [Printer
properties].
b. Clickthe[Ports]tab.