SATO CL4NX - Page 90

90
PJM Stack Tag (PJM Integrated)
ThisgroupofsettingsletsyoudeterminethePJM(PhaseJitterModulation)RFIDtag
properties.
[Maximum retry]
Setsthemaximumnumberofretryprintswhenanerroroccurs.
Thesettingrangeisfrom0to9.Ifyousetto0,theRFIDerrorscreenappearsand
printing continues.
[Module retry]
SetsthemaximumnumberofretrieswhenawriteerroroccursintheRFIDmodule.
Thesettingrangeisfrom0to9.Ifyousetto0,theRFIDerrorscreenappearsand
printing continues.
[RFID tag o󰀨set]
EnterthedistancefromthelabeledgetotheRFIDmodule.
Thesettingrangeisfrom0to240mm.
This setting will be used when labels are not compatible with the RFID antenna
positionsofyourprinter.Formoreinformationaboutcompatibleantennapositions,
refertotheOperatorManualofyourprinter.